Atmel flip software download serial#

Setup installation file needed for the software upgrade. This contains the special 'flip' software and its The downloaded file ( 458_Firmware_012914.zip) contains all theДЇLIP 2.4.6.zip. When the download window appears, click Save to begin the download process.

Download the software by clicking on the download button at.

(An example of this is a cable with a DB-9 maleД¬onnector on one end and a DB-9 female connector on the other end).

Atmel flip software download serial#

This is the Control Module to beДЄ PC with an RS-232 serial port (e.g., comДЄ standard serial cable to connect the PC To restore the echo feature, replace the id command above withД¤58-CC chassis.

The echo command may become disabled and it may seem as if there is noД¬ommunication. Press enter and to confirm that there is communication. = 8, parity = none, stop bits = 1, and flow control = none and then press 'oK.' Select a baud rate 9600 (Bits per second) to match the Select the proper COM port when the Connect To screen appears and then press 'OK.' It can be found at the following locations:Д®nter the name '458' when the Connection Description screen To use the PC, use the HyperTerminal program. Telebyte Control Module, use the id command from a data terminal or a PC To check which revision of software is loaded on the

The instructions to do this are as follows: To do this, use the HyperTerminal program It is also recommended that you verify your new firmware version Record the information, in the event it is needed at a later time. (Refer to Appendix 1 for DIP Switch Settings.)Д¬heck the firmware revision that is currently installed in the With this procedure before attempting to reprogram a Control Module.ДЇront panel.